hi i cant get mt head unit to go into program mode for my cd player, it just comes up cd safe and wont let me enter a code  , does this mean its been tried to many times , any help would be great thanks ricky

wrote on 20. Apr 2008 at 09:48:

hi i cant get mt head unit to go into program mode for my cd player, it just comes up cd safe and wont let me enter a code  , does this mean its been tried to many times , any help would be great thanks ricky

No it should mean that you have disconected it's power and have then subsequently reconnected it.

With radio off press AS button then turn radio on while holding button in.  Enter Radio pass code as instructed via buttons 1-4. The more you tryand fail  the longer it takes! :D

Lizzie Zoom :y :y

The CD code is entered almost as Lizzie says but you press CD & hold while you're turning the stereo on until you hear a confirmation bleep

The CD has its own code and to enter it you have to turn the radio off, then hold the CD key down and turn the stereo on whilst still holding the CD key down until you hear a confirmation beep the display should then show CD-Code for about 3 seconds. You can now enter the CD Code  :y Be careful though you only get 10 attempts

tryed all of thease but cant get the bleep to then enter code

wrote on 20. Apr 2008 at 09:48:

hi i cant get mt head unit to go into program mode for my cd player, it just comes up cd safe and wont let me enter a code  , does this mean its been tried to many times , any help would be great thanks ricky

Sorry!  I mean't to say CD button in my instructions!

I cannot however understand why you are not getting the bleep tone.  Are you holding the CD button in long enough? :o

Lizzie Zoom :)

Ign on, radio off.

Press and hold CD whilst you switch radio on. Release CD when you get beep.

TheBoy wrote on 20. Apr 2008 at 20:20:

Ign on, radio off. Press and hold CD whilst you switch radio on. Release CD when you get beep.

EchoEcho Echo Echo Echo Echo Echo  :y  :y  :y

Andy B wrote on 20. Apr 2008 at 21:34:

TheBoy wrote on 20. Apr 2008 at 20:20: Ign on, radio off. Press and hold CD whilst you switch radio on. Release CD when you get beep. EchoEcho Echo Echo Echo Echo Echo  :y  :y  :y

Ah, but nobody mentioned that Ign has to be on BEFORE turning radio on ;)

TheBoy wrote on 20. Apr 2008 at 22:00:

.... Ah, but nobody mentioned that Ign has to be on BEFORE turning radio on ;)

You're quite correct!  :y  :y

wrote on 20. Apr 2008 at 09:48:

hi i cant get mt head unit to go into program mode for my cd player, it just comes up cd safe and wont let me enter a code  , does this mean its been tried to many times , any help would be great thanks ricky

YES!  The ign must be on for the radio to be turned on!!! ;D ;D ;D

Does anyone not know that?  :o :o   ;D ;D ;D ;D ;D ;D lol

But you are right, it IS the kind of thing we ALL do; you know, go to use a drill without it being plugged in....... ;D :D :D

Lizzie Zoom :y :y

tryed all the above but still no bleep, radio works ok phone ok but no cd

Leave switched on (with ignition) for two hours - go for a long drive or something, after two hours (important not to turn the ignition off!!) try again.

If this fails, then will need to be reprogrammed.

8-)