Omega Owners Forum - Print Page

Omega Owners Forum
https://oldsite.omegaowners.com/forum/YaBB.pl Omega Help >> Omega General Help >> vacuum pipe removal https://oldsite.omegaowners.com/forum/YaBB.pl?num=1304682271 Message started by sandune on 06. May 2011 at 12:44

Title: vacuum pipe removal
Post by sandune on 06. May 2011 at 12:44

Advise/Suggestion on removing the vacuum pipe from the servo unit .Is any special tools needed or just gentle persuasion?
All suggestions welcome :yThanks :-?

Title: Re: vacuum pipe removal
Post by tigers_gonads on 06. May 2011 at 12:58

Always just pulled it off when i've done it :y

Title: Re: vacuum pipe removal
Post by Jimbob on 06. May 2011 at 13:01

this one?

pull out at servo end, 17 & 19mm spanner at plenum end

Title: Re: vacuum pipe removal
Post by sandune on 06. May 2011 at 13:08

Thanks lads ,what i thought looking at it ,better be sure than sorry later :y

Title: Re: vacuum pipe removal
Post by Marks DTM Calib on 06. May 2011 at 13:08

Yes, just pulls out at the servo end, depress the brake pedal 5 times or so with the engine off to destroy the vaccum in it as that makes it much easier.

Title: Re: vacuum pipe removal
Post by Osprey on 06. May 2011 at 17:36

If it still won't budge, try pushing it further on rather than pulling it off. Twist at the same time to break its seal, then pull it off once it starts moving.

This is because pulling makes the tube longer and thinner (ie tighter) but pushing makes it shorter and wider.

Hot water can soften things up - shouldn't be necessary tho.