Omega Owners Forum - Print Page

Omega Owners Forum
https://oldsite.omegaowners.com/forum/YaBB.pl Omega Help >> Omega General Help >> Omega sump depth? v6! https://oldsite.omegaowners.com/forum/YaBB.pl?num=1304864935 Message started by michaelprg on 08. May 2011 at 15:28

Title: Omega sump depth? v6!
Post by michaelprg on 08. May 2011 at 15:28

hallo!

I have a quick question! or 2!!

I need to know the depth of the sump from the engine mating face to the most deepest point (external)

and also the width of the sump wing ;)

I would greatly appreciate if some one could tell me these dimensions

Many thanks
Michael

Title: Re: Omega sump depth?
Post by Abiton on 08. May 2011 at 16:42

Which engine?

Title: Re: Omega sump depth?
Post by michaelprg on 08. May 2011 at 16:46

AH yeah sorry! v6!

Title: Re: Omega sump depth? v6!
Post by michaelprg on 08. May 2011 at 22:46

anyone? :-/ :D

Title: Re: Omega sump depth? v6!
Post by Albs on 08. May 2011 at 23:07

Are you including the alloy sandwich plate between the sump and block in your calculations ?
I dont know the answer to your question by the way.

Title: Re: Omega sump depth? v6!
Post by michaelprg on 09. May 2011 at 00:07

Albs wrote on 08. May 2011 at 23:07:

Are you including the alloy sandwich plate between the sump and block in your calculations ?
I dont know the answer to your question by the way.

Yeah :-/
its a pain to be honest i need to find out as i don't have my engine yet and i need to make my gear tunnel and without knowing my desired engine height its just a ball lake haha!

If your wondering i'm building a kit car :)

Title: Re: Omega sump depth? v6!
Post by Albs on 09. May 2011 at 00:11

I will try and remember to measure it tomorrow and post up my findings. :y

Title: Re: Omega sump depth? v6!
Post by michaelprg on 09. May 2011 at 00:12

Many thanks in advance!! :D

will be a huge help!! :y

Cheers
Michael

Title: Re: Omega sump depth? v6!
Post by Albs on 10. May 2011 at 09:58

OK - The widest part of the sump (front) is 470mm
From the bottom of the block to trhe bottom of the sump is 140mm (including the alloy part between bottom of block and top of sump.
The sump on its own is only approx. 45mm deep.
Hope that is of some help. :y