I'm about to replace the front passenger door airbag sensor.

I've got to remove the thin plastic skin to get at the wiring on the bottom strip (to check that too) and remove/replace the sensor.

Any tips for suitable adhesive to use for re-sealing when I'm putting everything back? Or will it remain sticky enough to re-affix without additional adhesive/

Anyone know?

Matthew

Mine usually get 'Gaffer taped' back on... This may not be suitable for vehicles equipped with side air bags though, hopefully somebody with more knowledge can advise!

MV6Matt wrote on 16. May 2011 at 17:58:

I'm about to replace the front passenger door airbag sensor. I've got to remove the thin plastic skin to get at the wiring on the bottom strip (to check that too) and remove/replace the sensor. Any tips for suitable adhesive to use for re-sealing when I'm putting everything back? Or will it remain sticky enough to re-affix without additional adhesive/ Anyone know? Matthew

Yes, as long as it`s peeled back carefully.......and try to avoid any splits/rips

I Put mine back on the first time with nothing on it.
The second time I used silicone. Peels away easy enough and holds it in place too

RobG wrote on 16. May 2011 at 18:20:

MV6Matt wrote on 16. May 2011 at 17:58: I'm about to replace the front passenger door airbag sensor. I've got to remove the thin plastic skin to get at the wiring on the bottom strip (to check that too) and remove/replace the sensor. Any tips for suitable adhesive to use for re-sealing when I'm putting everything back? Or will it remain sticky enough to re-affix without additional adhesive/ Anyone know? Matthew Yes, as long as it`s peeled back carefully.......and try to avoid any splits/rips

Thanks Rob!
Matthew

crossy wrote on 16. May 2011 at 18:31:

I Put mine back on the first time with nothing on it. The second time I used silicone. Peels away easy enough and holds it in place too

Thanks Crossy - I like your Car!
Matthew