Omega Owners Forum - Part No Help Req'd

Kev

Omega Knight

Offline

.:The OmegaProject:.

Posts: 1543
Glasgow
Gender: male

Part No Help Req'd
27. Jul 2006 at 20:05

Hi All,

Hopefully one of you guys will have the Vauxhall EPC and will be able to help me out here.

I'm about to change the stat on my Meega, a problem i've briefly spoke to Mark about. Thing is he said i will have to remove the bridge pipe to get access to it meaning i'd have to change the o-rings on said pipe.

So off i went to my local dealer, who, basically, didn't know what the part numbers were.

My car is a 2000 facelift but has the 3.0 v6, not the 3.2 It also has aircon, the guy reckoned it would make a difference. My engine number starts 0849----

If possible, can one of you kind chaps please tell me the part numbers for the following...

The thermostat...
The o-rings for the bridge pipe...
Temperature sensor (not the one for the fans in the rad, for the actual temp guage) (This was replaced last service as it was throwing up a fault on tech2)

Any other gaskets/seals i may need in the process.

I'd like to have everything i'll need there before i start, no ugly surprises as it were. Wink

Cheers.

Back to top

OmegaProject.co.uk .:. Fuelled with passion...

IP Logged

Jay w Omega Baron Offline omega gone Posts: 4445 Plymouth/Poole Gender: Drives: Alfa Romeo 156 Sportwagon Selespeed & Alfa Romeo Spider	Re: Part No Help Req'd Reply #1 - 27. Jul 2006 at 21:27 right then, here goes..... sensor 90541520 (later one) Stat 90502201 x1 stat to block seal 9128363 x1 stat to pipe seal9129999 x 2 bridge seals 90499400 x 4 can't see anymore seals that would be needed, hope that helps
Back to top	IP Logged

Kev Omega Knight Offline .:The OmegaProject:. Posts: 1543 Glasgow Gender:	Re: Part No Help Req'd Reply #2 - 27. Jul 2006 at 21:33 Cheers Jay for the kwik reply, You're an absolute star!! That's a drink i owe you.
Back to top	OmegaProject.co.uk .:. Fuelled with passion... IP Logged

v6man54deg Geffd

Junior Member

Offline

V6 man

Posts: 115
Wirral Merseyside
Gender: male

Drives: 3.0l v6 calibra

Re: Part No Help Req'd
Reply #3 - 27. Jul 2006 at 21:54

On the temp sensor - there are two on the coolant bridge - one is for the ECU (measured by Tech 2) the other is for the temp gauge (spade connector) this is not measured by tech 2

Kev wrote on 27. Jul 2006 at 20:05:

Hi All,

Hopefully one of you guys will have the Vauxhall EPC and will be able to help me out here.

I'm about to change the stat on my Meega, a problem i've briefly spoke to Mark about. Thing is he said i will have to remove the bridge pipe to get access to it meaning i'd have to change the o-rings on said pipe.

So off i went to my local dealer, who, basically, didn't know what the part numbers were.

My car is a 2000 facelift but has the 3.0 v6, not the 3.2 It also has aircon, the guy reckoned it would make a difference. My engine number starts 0849----

If possible, can one of you kind chaps please tell me the part numbers for the following...

The thermostat...
The o-rings for the bridge pipe...
Temperature sensor (not the one for the fans in the rad, for the actual temp guage) (This was replaced last service as it was throwing up a fault on tech2)

Any other gaskets/seals i may need in the process.

I'd like to have everything i'll need there before i start, no ugly surprises as it were. Wink

Cheers.

Back to top

V6 problems solved

IP Logged

Kev Omega Knight Offline .:The OmegaProject:. Posts: 1543 Glasgow Gender:	Re: Part No Help Req'd Reply #4 - 27. Jul 2006 at 21:57 So the 90541520 is for the ecu? Do you have the part number of the other sensor? I wish my EPC hadn't been used as a frisbee.
Back to top	OmegaProject.co.uk .:. Fuelled with passion... IP Logged

Jay w Omega Baron Offline omega gone Posts: 4445 Plymouth/Poole Gender: Drives: Alfa Romeo 156 Sportwagon Selespeed & Alfa Romeo Spider	Re: Part No Help Req'd Reply #5 - 27. Jul 2006 at 22:17 the one i have quoted you for is the one that is asscioated to the ECU, i think it helps to control the cold running as well, it has a two pin multiplug the other one has the part number 3439088, has been used by vaux for years in nearly everything that have on the road and is for the guage on the dash HTH
Back to top	IP Logged

Kev Omega Knight Offline .:The OmegaProject:. Posts: 1543 Glasgow Gender:	Re: Part No Help Req'd Reply #6 - 27. Jul 2006 at 22:32 Cheers again. Is that another drink then?
Back to top	OmegaProject.co.uk .:. Fuelled with passion... IP Logged

Kev

Omega Knight

Offline

.:The OmegaProject:.

Posts: 1543
Glasgow
Gender: male

Re: Part No Help Req'd
Reply #7 - 28. Jul 2006 at 19:54

Been to Vauxhall today to order required seals, with a major problem...

The bridge seals '90499400 x 4' are priced at an astonishing £50 each!! That's £200 for 4 seals?

Surely that's a typo someone has made at Vauxhall, cos i'm thinking 50p each, not 50 quid each.

I assume someone on here has had to buy these before, and would remember if they had to shell out 50 quid each on 'em, is this right?

Back to top

OmegaProject.co.uk .:. Fuelled with passion...

IP Logged

Marks DTM Calib Administrator Offline Ex Member Posts: 25671 Northern Hemisphere Gender: Drives: Astra J, Mum Bus, Dexta Tractor, 108 DMU wip	Re: Part No Help Req'd Reply #8 - 28. Jul 2006 at 22:16 The coolant bridge (at the rar of the valley bridging the two heads) seals are actualy 12992647 at £1.39 each........and you dont need to remove the bridge to do the stat! The coolant bridge pipe (from the stat to the rad top hose) seals are 9120007 at 67p each two off required
Back to top	IP Logged

Kev Omega Knight Offline .:The OmegaProject:. Posts: 1543 Glasgow Gender:	Re: Part No Help Req'd Reply #9 - 28. Jul 2006 at 22:19 And i breath a sigh of relief! Cheers Mark.
Back to top	OmegaProject.co.uk .:. Fuelled with passion... IP Logged

Jay w Omega Baron Offline omega gone Posts: 4445 Plymouth/Poole Gender: Drives: Alfa Romeo 156 Sportwagon Selespeed & Alfa Romeo Spider	Re: Part No Help Req'd Reply #10 - 28. Jul 2006 at 22:52 hmmmmmm....wierd.. when i check again for the seals it comes up with the part number 90499400 i gave you.... item number 22 Maybe my EPC is getting a bit old, time for a newer version if i have got it wrong please accept my apologies
Back to top	IP Logged

Kev Omega Knight Offline .:The OmegaProject:. Posts: 1543 Glasgow Gender:	Re: Part No Help Req'd Reply #11 - 28. Jul 2006 at 23:15 Jay w wrote on 28. Jul 2006 at 22:52: if i have got it wrong please accept my apologies No problem, don't worry about it. I just freaked a bit at the price. I'll let you know how i go at Vauxhall with the new part numbers. Thanks again for your help, it's much appreciated.
Back to top	OmegaProject.co.uk .:. Fuelled with passion... IP Logged

This is the old site. Please use the new site.

This is the old site. Please use the new site.

www.omegaowners.com/forum/index.php.

This is the old site. Please use the new site.

	Welcome, Guest. Please Login