Hi guys.

I'm doing my breathers and have a blocked pipe.  Its the smallest one, no. 3 as seen in the pic below:



I've stuck a long wire down the whole length of the pipe but it seems to be the bottom bit where it comes out of the middle that's blocked.

I took this picture from the maintenance guide and cant work out exactly where the exit point for this pipe (purple line) is.  If I know that, maybe I can unblock it.

I've prodded around as much as I can with a thin bag tie wire but am not certain where to poke?

Can anyone offer advice on clearing this please?

Cheers

Neil

There are pin holes in the circular portion as in the photo insert.

A strand from a wire brush, held in vice grips and wriggle it in with copious carb cleaner....

Hi Neil I had the same would not move then put on the water hose , hose over the small hole and it will get all that muck out. Took 5 mins to clean all the holes.

When the water runs out clear you know your done

Hope that helps all the best

steven