This is the old site. Please use the new site.

  Welcome, Guest. Please Login
Omega Owners Forum
 
  Home Shop Help Search Members Login  
 

This is the old site. Please use the new site.

www.omegaowners.com/forum/index.php.

 
Page Index Toggle Pages: 1
Send Topic Print
Removal of F/L front bumper (Read 11116 times)
RobG
Omega Lord
*******
Offline


I might have a link, pic
or part number for that

Posts: 7968
Bristol
Gender: male

Drives: 53 plate 2.2 CD auto
Removal of F/L front bumper
07. Jun 2011 at 21:57
 
The front bumper is held on with a total of 9 fixings, 4 x torx screws and 5 expanding lift/push "plugs".
2 x torx on each side

...

2 x "plugs" under bonnet and 3 underneath the bumper

...

Pics of the "plugs" under bonnet. Release these by lifting centre of plug with small flatblade screwdriver inserted into visible slot.

...

...

...

Then remove under headlight trim, some are held in with a pushpin (the hole at trim end) but most are just secured with the rubber "hook". Release the trim and pull outwards steady, the other end unclips.

...

...

Pics of "plugs" under bumper. Same procedure to release.

...

This pic shows the "plugs" in situ with bumper upturned.

...

Next undo the 4 x torx screws (2 each side) at bumper ends.

...

...

You can now pull the bumper towards you to release it. Unplug the multi-connector near the horns

...

If headlamp washers are fitted unclip the connector at the washer pipe by pushing the retaining clip

...

If you need to remove the steel bumper bar it`s held on with 4 nuts (2 each side) and the washer reservoir is fixed to the bar via 4 x torx screws.

...

...

Job done
Back to top
« Last Edit: 08. Jun 2011 at 08:23 by Jimbob »  

TC Holder Maxscan GS500 OBDII code reader/EML resetter available..
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print

This is the old site. Please use the new site.