This is the old site. Please use the new site.

  Welcome, Guest. Please Login
Omega Owners Forum
 
  Home Shop Help Search Members Login  
 

This is the old site. Please use the new site.

www.omegaowners.com/forum/index.php.

 
Page Index Toggle Pages: 1
Send Topic Print
code73 car cuts out while driving. 3.0 v6 1996auto (Read 323 times)
doug4293
Intermediate Member
***
Offline



Posts: 264
greenock, scotland
Gender: male

Drives: 3.0 v6 24v elite, 2.0 16v corsa, 1.9dturbo 306, gsxr600
code73 car cuts out while driving. 3.0 v6 1996auto
26. Mar 2011 at 19:14
 
was driving last night about 40mph, the ecu light came on for about 10 secs and then wen offf again, continued to drive it then 5 mins later,, at 40mph-ish  the car cut out as if the ignition had been turned off, so i put it i N and pulled over to side of road. started the car again and it was a bit spluttery then ran fine, drove it again for anouther 5 mins and it cut out again, again pulled over and when tried to start it this time, it just cranked and spluttered. waited a min and tried starting it again and it started no problem, managed to drive it 25 miles home and its been ok. i paperclipped it today and got these codes
144 No immobiliser signal recived Faulty unit or break in wiring
73 Air Flow Sensor (AFS) Low voltage
31 Engine RPM signal (crankshaft sensor) No signal

i recon i can ignore 144 and 31, but 73 may be the problem ?
i discinnected the air flow sensor today and started the car and it runs fine but ecu light stays on, reconnect it and no light. just wondering if i need to replace it, and would this cause it to cut out ? as it runs when its disconnected ?
just dont want to get stranded anywhere.
Back to top
« Last Edit: 26. Mar 2011 at 19:15 by doug4293 »  

Signature deleted as it's too big.
doug4293 doug4293  
IP Logged
 
Varche
Omega Baron
******
Offline



Posts: 3860
Andalucia, Spain
Gender: male

Drives: 97 pre mini facelift 3 litre auto RHD Elite saloon  and a 2000 Ford Ka !
Re: code73 car cuts out while driving. 3.0 v6 1996auto
Reply #1 - 26. Mar 2011 at 20:00
 
Could well be your MAF (AFS). I had a similar problem and it ran OK with the MAF disconnected. Two possibilities. A new or secondhand MAF with the same part number OR an EBay aftermarket sensor. I did the latter and it was about £40 inc postage. People have suggested cleaning but you need to be careful as it is very sensitive. Bit inconvenient the cutting out especially in an auto!

Don't forget that after you cure the problem the codes are stiull stored for about twenty clean starts before they go.
Back to top
 

Finished breaking the red mfl Elite saloon in Spain. Got a shed load of stuff. Will post parts.
 
IP Logged
 
TheBoy
Administrator
****************
Offline


TBE has an MOT!

Posts: 64817
Brackley, Northants
Gender: male

Drives: 98 MV6, 03 Elite, 00 25, 89 ZX10
Re: code73 car cuts out while driving. 3.0 v6 1996auto
Reply #2 - 26. Mar 2011 at 20:09
 
Unplug the MAF as a test, the car should run (albeit not to perfection). If so, then replace the MAF.

If it still cuts out, things to be suspicious of are crank sensor, ICV (only at idle) and EGR.
Back to top
 

If you are going to kick a car, remember to wear appropriate footwear
Any posts are the result of my own views as a member of OOF, which may or may not be the same as my views as part of the Admin Team.
WWW  
IP Logged
 
MutantCav
Omega Baron
******
Offline



Posts: 4585
Gainsborough
Gender: male

Drives: 3.0 2000 Mini Facelift Elite Saloon
Re: code73 car cuts out while driving. 3.0 v6 1996auto
Reply #3 - 26. Mar 2011 at 22:15
 
If the 144 was genuine rather than being a red herring symptom of the actual failure then perhaps this is why the engine cut out?? If the ECU doesnt receive an immoboliser signal the engine wont run
Back to top
« Last Edit: 27. Mar 2011 at 00:42 by TheBoy »  

Lots of Omega Parts Available...Anyone Need Anything??
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print

This is the old site. Please use the new site.